P0030 2011 FORD FUSION - HO2S Heater Control Circuit Bank 1 Sensor 1

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3

P0030 2011 FORD FUSION Causes

  • Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit open shorted to ground
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
  • P0030 2011 FORD FUSION Notes

    If the sensor and connector are OK, replacing the O2 Sensor 1 usually takes care of the problem.

    First diagnose P0030 2011 FORD FUSION code

      Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

    Cost of diagnosing the P0030 2011 FORD FUSION code

      Labor: 1.0

      The cost of diagnosing the P0030 2011 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

    P0030 2011 FORD FUSION Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • P0030 2011 FORD FUSION More Information

    Need more information on how to fix the P0030 2011 FORD FUSION code?
    Get Access to Factory Service Manuals

    P0030 2011 FORD FUSION Description

    The powertrain control module (PCM) monitors the heater in the heated oxygen sensor (HO2S) for correct operation. The PCM controls the heater on/off duty cycle to maintain a temperature of 780°C (1,436°F). The test fails when the sensor does not warm up to the required temperature in a calibrated amount of time. The test also fails when the PCM is not able to maintain the required temperature after the sensor is warm.