P0448 2012 NISSAN ROGUE - Evaporative Emission Control System Vent Control Circuit Close
P0448 2012 NISSAN ROGUE Causes
P0448 2012 NISSAN ROGUE NotesVery common problem with Nissan vehicles. Before replacing any parts, check for damage EVAP canister and for loose hoses from the vent control valve to the canister.
First diagnose P0448 2012 NISSAN ROGUE code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
Cost of diagnosing the P0448 2012 NISSAN ROGUE code
Labor: 1.0The cost of diagnosing the P0448 2012 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
P0448 2012 NISSAN ROGUE Symptoms
P0448 2012 NISSAN ROGUE More InformationNeed more information on how to fix the P0448 2012 NISSAN ROGUE code?
Get Access to Factory Service Manuals
P0448 2012 NISSAN ROGUE DescriptionThe Evaporative Emission System (EVAP) canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid (the EVAP canister vent control valve) responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system componentsThis solenoid valve is used only for diagnosis, and usually remains opened. When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows EVAP Control System (Small Leak) diagnosis.